Feiyu-tech FY-41AP Manuel d'utilisateur télécharger pdf (Page 23)

Guilin Feiyu Electronic Technology Co., Ltd

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn ser[email protected]

- 23 -

Attempt to fly

To use the default control parameters, execute Combination Stick Commands (CSC)

in stabilized mode and takeoff. Manually control the aircraft and attempt to hover at the

height of about 1 meter. Get a feel for the attitude stability, and then manually change

the attitude through your RC, and then loosen the RC sticks and observe the aircraft

auto-recovery levels and retention capacity. If improper, then land the aircraft and perform

further debugging.

Install propeller

In order to install the propeller, please follow the motor rotation direction according

to the pictures found in the ―Motor Mixer‖ section on page 20 of this manual.

Check the control direction of RC corresponding channel

After installation is complete, please execute Combination Stick Commands (CSC)

in stabilized mode or in Hovering mode (Can not in Auto Return To Launch

Mode(RTH) ) to start motors. Slowly push the throttle but do not take off. Check the

control surfaces of the joystick remote control and make sure the aircraft direction is

correct.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

Feiyu-tech FY-41AP Manuel d'utilisateur Page 23