Feiyu-tech FY-41AP Manuel d'utilisateur télécharger pdf (Page 13)

Guilin Feiyu Electronic Technology Co., Ltd

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn ser[email protected]

- 13 -

Main Module Installation

FY-41AP module installation

 While installing, please keep FY-41AP horizontal and as close

as possible to the "Centre of gravity" (COG) of the aircraft.

The module‘s orientation can be changed by FY-GCS

(Ground Control Station) system: arrow to front (default), back, left or right. Please reset the

―install orientation‖ after you changed the install orientation.

 Efficient anti-vibration components are very important and to be used when installing. You

can use the included ‗vibration absorbing dampers‘ or your DIY equipment. Please note: For

Nitro planes, flying without using efficient ‗anti vibration damper‘s‘, will lead to FY-41AP

working abnormally.

 The better the damping installation is, the better attitude control and GPS hovering functions

are.

 Each modules installation to a suitable position is conducive to further enhance the

performance of Hovering mode. Regarding 41AP module installation position, the center of

the aircraft should be as far away as possible from other objects that could cause

interference. The aim is to reduce the disturbance to the internal IMU position sensors

when the aircraft tilts or rotates. In addition, you also have to consider a very important factor:

reducing the interference to the 41AP internal magnetic sensor due to positioning during

installation. There will be interference to magnetic sensor, from surrounding objects with a

strong current, motor rotation, battery, etc. Keep potential interfering objects as far away as

possible during installation. Keeping these two factors in mind, please find a suitable position

for installation. For example, you can put the FY-41AP module on a high place.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 30 31

Pas de commentaire

Feiyu-tech FY-41AP Manuel d'utilisateur Page 13