Feiyu-tech FY-41AP Manuel d'utilisateur télécharger pdf (Page 13)

Guilin Feiyu Electronic Technology Co., Ltd

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn ser[email protected]

- 13 -

Main Module Installation

FY-41AP module installation

 While installing, please keep FY-41AP horizontal and as close as possible to the

"Centre of gravity" (COG) of the aircraft. The module‘s orientation can be changed by

FY-GCS (Ground Control Station) system: arrow to front (default), back, left or right.

Please reset the ―install orientation‖ after you changed the install orientation.

 Efficient anti-vibration components are very important and to be used when installing.

You can use the included ‗vibration absorbing dampers‘ or your DIY equipment. Please

note: For Nitro planes, flying without using efficient ‗anti vibration damper‘s‘, will lead

to FY-41AP working abnormally.

 The better the damping installation is, the better attitude control and GPS hovering

functions are.

 Each modules installation to a suitable position is conducive to further enhance the

performance of Hovering mode. Regarding 41AP module installation position, the

center of the aircraft should be as far away as possible from other objects that could

cause interference. The aim is to reduce the disturbance to the internal IMU position

sensors when the aircraft tilts or rotates. In addition, you also have to consider a very

important factor: reducing the interference to the 41AP internal magnetic sensor due to

positioning during installation. There will be interference to magnetic sensor, from

surrounding objects with a strong current, motor rotation, battery, etc. Keep potential

interfering objects as far away as possible during installation. Keeping these two factors

in mind, please find a suitable position for installation. For example, you can put the

FY-41AP module on a high place.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Pas de commentaire

Feiyu-tech FY-41AP Manuel d'utilisateur Page 13