Feiyu-tech FY-41AP Manuel d'utilisateur télécharger pdf (Page 23)

Guilin Feiyu Electronic Technology Co., Ltd.

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn ser[email protected]

Page 23

AILERONS - Roll the plane to see the following action:

 Incline the plane to the right (roll right). The ailerons should give a control signal to

counter this roll direction (see below). Same as when rolled to the left. If the ailerons

move correctly, the knob has been turned in the right direction. You can now adjust gain

by moving nearer (low gain) or further away (high gain) from center;

 If the ailerons do not follow the movements shown above, simply turn the aileron knob to

the opposite side (beyond centre). You should now see the correct aileron movement.

RC setting、SW1&SW2 channel setting

FY-41AP requires a minimum of 6-channel RC receiver.

① First, the remote control is set to fixed-wing aircraft of conventional layout

mode, do not set any mixing. The rudder angle of the remote control is set to 100%,

and fine-tune gyrus.

② Need two three-stage switch or rotary switch settings for CH5, CH6 used to

connect SW1 and SW2. Used to switch the flight mode.

③ Connection is completed, the call CH5, CH6 check the settings are correct

control mode, the status of the lights, or OSD display mode to confirm.

④ To switch to manual mode, check the control surfaces of the joystick remote

control aircraft direction is correct, if not correctly adjusted positive on the remote

control rudder control to correct the reverse.

⑤ Switch to the "Auto Balance Mode" mode, check the control direction as

explained below.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Pas de commentaire

Feiyu-tech FY-41AP Manuel d'utilisateur Page 23