Feiyu-tech FY-DOS Manuel d'utilisateur télécharger pdf (Page 14)

Guilin Feiyu Electronic Technology Co., Ltd.

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn ser[email protected]

Page 14

E. ESC/ THROTTLE control surface movement check

ESC/throttle can be set by DOS setting software or RC controller. First, adjust throttle‘s control movement

on RC controller, roll throttle stick on lowest position, then on SW1, switch ABM to 3D mode 6 times, time

interval has to be less than 3 seconds as follows:

ABM→3DMode→ABM→3DMode→ABM→3DMode→ABM→3DMode→ABM→3D Mode→ABM→3D

Mode, there is a yellow lamp will light up once, it‘s done.

15. Gyroscope Reset

If the following conditions occur, the DOS initialization is recommended:

(1) The device has not been used for a long time.

(2) There is a change in environmental temperature of over 30 degrees since last flight.

(3) The purple LED flashes continuously even when the DOS remains stationary and you never activate the

motor.

Note:

● Carry out this re-setting procedure only if the above occur. We do not recommend regular re-setting. It is

not necessary and not recommended.

● The stabilizer unit does not need to be in a horizontal position during initialization. However, you must

ensure there is no vibration during this process. If suspect shaking occurred during the procedure, just restart

the initialization / resetting process.

Initialization / Reset Process:

1) Power on and keep stationary.

2) Switch to ABM.

3) On SW1,switch ABM to Deactivated Mode 6 times, time interval has to be less than 3 seconds as follows:

ABM→ Deactivated Mode → ABM → Deactivated Mode → ABM → Deactivated Mode → ABM →

Deactivated Mode → ABM → Deactivated Mode → ABM → Deactivated Mode.

4) DOS indicator will flash white about one second.

5) After white lamp lights off, the re-setting / initialization is complete.

(If you connect a DOS setup software, you can initialize it by click "Init GYRO" button.)

16. DOS Setting Software:

Connection mode

USB Cable

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Feiyu-tech FY-DOS Manuel d'utilisateur Page 14